SPC Rules 2018

SPC Rules
IEEE Region 8 Student Paper Contest

1. Once every year, each IEEE Student Branch (SB) may hold a Student Paper Contest (SPC) under its own responsibility.
2. The winner(s) of each Branch Contest may compete for the Region 8 Contest, held within the Region limits. A Branch may submit one paper for every 100 branch members or part thereof, with a maximum of three papers.
3. However a paper can be submitted by a student branch if the student branch counselor supports the paper and the paper is within the valid rules for submission.
4. At Region 8 Contest an international Jury, will grade the written papers without knowledge of the identity of the author and of his school. Jury will decide which papers will be accepted for presentation at the Region 8 SPC oral finals.
5. Only IEEE student members and IEEE graduate student members are allowed to be authors of the SPC papers. Each author has to be a member of an IEEE R8 Student Branch at the time of the original submission of the paper to the Branch Contest and a member
(student or not) of the IEEE at the time of the oral presentation. The work presented has to be completed before the student receives the engineering degree that entitles him/her to start preparing a doctoral thesis and the submission of the paper to the Region 8 Contest must be completed within 12 months after graduation. A doctoral thesis is not considered.
6. Although the original paper – i.e. the paper that was submitted to the local Branch Contest – may be written in any language, the paper that is submitted to the Region 8 Contest should be in English. The oral presentation shall be in English, as well.
7. When entering a paper in the Region 8 Contest, ach SB Counselor will provide a document certifying that condition 5
is fulfilled, giving the IEEE membership number(s) of the author(s), and stating during which year(s) after high school the work has been performed. Any other useful information concerning the work and background is welcome. This document should be attached to the Student Paper Cover Sheet (see “Author Guidelines on Paper Layout” and “Student Paper Cover Sheet”).
8. Finalists selected by the Jury will be invited to present their papers at one of the Region 8 Conferences. If acceptable to
the organizers of the conference at which the oral finals take place, the papers that have been accepted for oral presentation will be published in the proceedings of that conference and possibly included in IEEE Xplore Database. Since the five finalist papers are being included in the conference proceedings as well as in IEEE Xplore Library, the rules will now allow that the name of the supervisor/mentor may be added, as an author, to the final version of the paper sent to the conference organisation. This
does not change in any way the basic rule that the submitted paper is the work of the student.
Electronic versions of the finalists’ papers will also be published in the IEEE Region 8 SAC web pages.
9. Travel expenses (train 2nd class, or plane economy class for very long distances) will be provided by the Region 8 Student Activities Fund to one author of each paper accepted by the Jury for oral presentation. Living expenses which may occur while attending the oral presentation may also be reimbursed; the guidelines for this reimbursement will be mailed to attendees before the presentation.
10. The IEEE Life Member Fund is supporting IEEER8 and awarding three prizes of 800, 500 and 200 US Dollars for the first, second and third placed papers respectively. Furthermore, the Region 8 Student Activities Fund offers 250 US Dollars as the “Dick
Poortvliet Award” to the branch where the winner comes from.
11. Published work is excluded from the Contest. Any paper subsequently published should mention an acknowledgement of the received award.

12. Papers should cover technical and engineering aspects of a subject reasonably within or related to the areas with which the IEEE is concerned with.
13. The work need not be original in engineering content, but should be original in treatment and concise in coverage of the author’s contribution to the subject.

14. The paper must be typewritten on A4 size paper (210 mm × 297 mm), with the text width equal to 183 mm and the text height equal to 243.5 mm; a font size of 10 pt or larger should be used. The two-column IEEE Transactions style (with the space between columns equal to 4.1 mm) isrequired.
15.The paper should not exceed six (6) pages. Overlength papers will not be considered for the contest!

16.Send papers by email to r8sac@ieee.org.
It is required that the version of the paper sent to the Region 8 Contest does not show the identities of the authors and their educational establishments. The paper MUST be accompanied by the Student Paper Cover Sheet (separate doc file) (see 23 below), the SB Counselor certification document from point 7 (separate scanned file), and the signed IEEE Copyright form 17.
The submission deadline is 1 December 2017.

18. Those authors selected to give an oral presentation should develop a pleasant and logical
presentation of the subject matter fitted to 15-20 minutes. The Jury will question each
contestant for an additional period of 10 minutes typical.
19. An electronic presentation – based on Power Point, for instance – using a beamer (LCD data projector) is preferred. Additional presentation tools may be provided if a request is made and granted in advance. The presentation should not attempt to cover the entire paper, but rather to give a general idea and enlarge on one or two specific points.

20. There shall be maximum five judges within Jury.
21. The contributions are graded as follows.

written paper

  • technical content: 45 points maximum,
  • technical presentation: 25 points maximum,

oral presentation: 30 points maximum.
22. A preliminary selection based on the written document may be made by the members of the jury,either if too many papers are submitted or if so me papers do not reach the expected level or formal requirements.

Since the judges must handle the papers without knowledge of the identity of the author and his educational establishment, it is required that the paper itself show no such identification other than the title.
The title, author(s)’ name(s) and IEEE membership number(s), corresponding author’s address, school, and Branch Counselor’s name must be shown on a removable cover sheet.
TheCounselor’s certification document should be removable too.
23. Student Paper Cover Sheet Answer concisely and completely the questions in the form below, and send it as a separate file (doc) together with the paper. Only the second part of the Cover Sheet, Section B, will be sent to Jury and will help in grading the paper.
Author(s), with their IEEE membership number(s):
Name, address, contact phone and e-mail of author to whom correspondence should beaddressed:
Name, address, contact phone and e-mail of Student Branch Counselor
Name, address, contact phone and e-mail of Student Branch Chair
Section B
Paper title:
What is the problem and why is it important?
What is the original contribution of this work? Be explicit.
Does this work check and / or extend previously reported work? What work? Give references. Be explicit.
How does this contribution compare to previously published work?
If the paper is to be submitted to one of the IEEE Transactions, which Transactions would be the most appropriate?

The following guidelines are suggested to assist grading by providing a uniform layout. In general, the paper should be organized as follows:
Title page.
The title should consist of the minimum number of key words necessary to portray accurately the content of the paper. Reader’s interest is stimulated by a well – chosen title. The author’s name should not appear on the title page, nor should any other name
of persons or schools.
The abstract should not describe the paper, but should give in brief the essential facts of its content, for example, a brief statement of the problem or objective and a concise summary of results or conclusions, touching upon methods or other details only if they are
unique or if they are of some particular significance. The abstract should be no longer than 100 words.
The introduction should lead to the development of the subject so that the reader may obtain a clear understanding of the significance of the paper. This often can be done by giving briefly the state of the art as background. Then bring out the added
advantages of the method of approach and emphasize the importance of the results or conclusions.
The main argument of the development of the subject is carried out in the body of the paper, complete with supporting data. The argument should proceed in a logical sequence according to a prepared outline. The writing should be in the third person. Supporting data and results can often be presented most effectively as curves, charts or tables. Well – known abbreviations may be used in the text but should be defined where used the first time, followed by the abbreviation in parentheses. Generally, the use of abbreviations should be confined to not duplicate text matter.
The conclusions are often considered the most important part of a paper. They should be stated concisely in a separate section at the end of the paper. If there are three or more conclusions, greater emphasis can be obtained by numbering each conclusion and setting it off in a separate paragraph.
Tables should be numbered consecutively using Roman numerals. Small tabulations or listings may be made in the text where necessary for continuity. Each table should be titled by giving a brief description as a heading following the table number at the top. Ditto marks should not be used in tables, but brackets may be used to group information common to several lines.
Three types of diagrams may be used:
photographs, oscillograms, line drawings.
Keep reading matter on illustrations to a minimum; include it in the captions. Portions of illustrations may be identified by letters and explained in the captions. Whenever feasible, combine several curves on the same coordinates. Their identifying letters or numbers should be in clear spaces between cross-section lines. If it is necessary to place data over cross-section lines, erase these lines.
Detailed mathematical proofs, development of equations, and examples which are subordinate to the main argument in the body of a paper, but not essential to following the argument, should be treated in appendices. References are made in the text to details in the
appendices. Main equations as they are developed should be numbered consecutively, with the number in parentheses opposite the equation in the right hand margin.
Any information or development taken from books, periodicals or courses, i.e. from any external source, should be clearly referenced in the text and a suitable reference list should be appended to enable the reader to consult those sources. References should be
numbered consecutively and should follow the form shown below:

For a periodical: R. N. Hall, “Power rectifiers and transistors,” Proc. IRE, vol. 40, pp.1512–1519, November 1952.

For a book: W. A. Edison, Vacuum Tube Oscillators, Wiley, New York, pp. 170–171, 1948.

The following criteria are suggested to provide a uniform
grading standard:

Do the authors present their independent work?

Is the significant amount of presented work new? Do the authors present a novel interpretation of some existing work?

Is the subject matter of substantial technical content and is it presented at an acceptably advanced level?

Is the 100-word abstract concise, informative and accurate?

Does the written presentation include a satisfactory introduction which properly orients the reader with respect to the general area with which the paper deals? Does the concluding portion of the paper summarize the reader’s impression of what the
work has accomplished ? Are the conclusions supported by evidence?

Does the exposition (and analysis which may be involved) proceed in an orderly and logical manner?
Is the paper self-contained?

Does the author exhibit ingenuity and resourcefulness in methods of presentation, choice of illustrations, use of analogies and the like?

Is the paper technically accurate?

Is an unmistakable meaning conveyed with acceptable brevity?

Is the format and typesetting quality of the paper appropriated?